At that point, it’s probably for the homeowner time to consider replacing the windows. Often, this aging occurs without anyone noticing until suddenly a window won’t open, a guest feels a ferocious draft, or the homeowner sees that the heating and cooling bill is much higher than usual. But over time, the insulation qualities begin to fade, flashing ages, and caulk and weatherstripping crack and dry out-not to mention the eyesore that old, faded windows can be. And windows often aren’t at the top of a homeowner’s maintenance list unless they stop working correctly. They’re opened and closed frequently and are the barriers between the home’s interior and heat, cold, wind, rain, and snow. *Titebond WeatherMaster - Translucent (#44011) is not paintable.Windows, however, are also under constant use and abuse. Contact with asphalt or butyl may cause discoloration, but will not affect product performance. For best results, store in a dry location at or below 75☏. Sealant releases methanol during cure, check with substrate manufacturer for compatibility. Check with polycarbonate supplier on compatibility. Application of sealant at high temperatures may cause the sealant to sag in some applications. It is highly recommended to use backing material. Once sealant is applied, do not wipe with solvents or tooling aids such as soaps or oils. Air, sealant and surface temperature should be above 0☏. Limitations: Not designed for continuous submersion or use below the waterline. Follow solvent vendor’s precautions when using solvents. After curing, excess sealant must be cut or scraped away. Cleanup: Clean uncured material with acetone or isopropyl alcohol. For other paint types, a compatibility test is recommended. In most cases, painting may occur one hour after application with a high-quality acrylic, water-based (latex) paint that does not contain plasticizer. If used indoors, sealant may need to be painted. Painting: Sealant is intended for exterior use. For questions, please call our Help Line at 1-80. Do not apply WeatherMaster Translucent to polycarbonate due to solvent cracking. For use on polycarbonate, check with polycarbonate supplier on compatibility. Substrate Compatibility: If application is for Kynar™ coated materials, use WeatherMaster Metal Roof Sealant. It is the sole responsibility of the user to thoroughly test any proposed use with all substrates to determine project suitability. Once sealant is dry to the touch and does not transfer, remove masking tape. To ensure neat sealant lines, mask areas adjacent to joints. Screw nozzle onto cartridge and cut tip on slant for 1/4" to 3/8" bead and place in cartridge gun. Remove nozzle, cut tip of the nub and puncture inner foil seal. Surfaces must be clean and free of any material that may prevent adequate adhesion. to 212☏ (-59☌ to 100☌) white & colors, -75☏ to 250☏ (-59☌ to 121☌) crystal clear (may discolor at higher temperatures), -40☏ to 400☏ (-40☌ to 204☌) translucent Method of Application: Cartridge/caulking gun Tooling Time: For a 1/4" bead, approximately 10-15 minutes, depending on temperature and humidity. Application Temperature: Above 0☏ (-18☌) Service Temperature Range: -75☏. Application Guidelines Complete Installation Instructions: For complete installation instructions, please visit our Sealant Installation Guide for more information.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |